Super Shrinkwrap

Introduction

Blender Addon to fit sub division surface to reference data.

Installation:

The add-on is a zip file. Do not unzip the file. Open Blender. Go to preferences, add-on. Click on Install and point to the zip file. Click the check mark to enable the addon.

A new side panel called Super Shrinkwrap is now enabled.

• The first row shows the active object that is selected. If no object is active or and invalid object is selected, "Select object" is displayed.
• The second field is for the reference object. You can use the eye dropper function to select the reference object.
• Subd level controls the number of subdivisions. The default value is 2. It can be changed from 1 to 6.
• The next field controls the number of iterations to run to get close to the required tolerance. The default value is 3. This can be changed between 1 and 10.
• The third column shows the tolerance is millimeters for the deviation map. The default value is 2 mm.
• The next row displays the tolerance achieved.
• The button "Fit Subdiv" will fit the selected mesh with the subdivision modifier. It will add a subdivision modifier if not already applied.
• Additionally a deviation map is displayed showing the deviation. Red color for positive and blue for negative deviation. The color green indicates areas within tolerance.

Version:

• 1.1:
  • Enhancement: Aiblity to control the subdivision levels
  • Enhancement: Ability to undo changes.
• 1.0: Initial Release